All in One Clamp RP 8-Inchx 9-Inch Router Plate

List Price: $33.99 Discount Price: $26.99

Features:

• Router tracks perfectly along the straight edge
• Base locks onto the t-track
• Keeps your router in control
• Eliminates router kick for a smooth cut
• Crystal clear polycarbonate to see your cuts

Customer Reviews:

A definate improvement over the clamp by itself [Posted on 2007-09-27]
I used this with an all in one clamp I purchased at another store. I was cutting a 1/4 inch dado into 3/4 oak ply. I made test cuts with and without the plate using a 2 1/4 HP Bosch router. I found the cuts with the plate much easier. Installaton was a snap because there were predrilled holes for my router base. Simple product to use, and it make the job a lot easier. Please take into account that I am a beginning woodworker, those with or experience may not need this type of tool, but for me, this worked well, and with little setup. This makes the dado cuts so easy that I am going to forget using a dado blade in my tablesaw. I would highly recommend. Good luck.

Really Really Poor [Posted on 2007-10-28]
I ordered this item some time ago, and each time I check the shipping date it goes further and further back. If the item is truly not in stock, to tell people it will ship in 4-6 weeks when you know it will not ship in that time frame; is deceptive and bad business. I find Amazons response to this issue completely unacceptable, and I hope you do too.

ATLNorm [Posted on 2008-01-10]
I bought the router plate, the wide jaws and the 50" clamp a few months ago, for a particular project requiring lots of dadoes in MDF. The whole system works as advertised, and is well worth the modest cost. A couple of notes--I probably over-tightened the clamp, causing a piece of the cam-lever to break. It hasn't ruined the clamp, but I assume the overall clamping pressure has been diminished. Second, I used a cheap router bit and pushed it so hard that I melted the router plate. That said, I sent a simple email to the manufacturer inquiring about replacement parts (and explaining the problems, even admitting my responsibility), and in less than two hours, the company responded with an offer to replace the parts (no cost). That's customer service.

Great product, and a great company that stands behind its product.

no slide [Posted on 2008-01-20]
the router and circular saw slide are hard to attach to the saw in particular. both do not slide on the rail with out forcing them which results in a bad cut or rout job. would not buy these again or recommend them to anyone.

Junk [Posted on 2008-02-05]
First, none of the many pre-drilled holes fit my very common Porter Cable router. Second, although there is a hole for a screw to attach it to the T-track in the clamp, one is not provided. But thirdly and most frustratingly, the slot in the plastic for the clamp's track to go through is too tight so it gets stuck. I twice got my router halfway through the piece and simply could not budge it any farther. I threw the damn thing away, another $20 wasted.

Click here for more details and discount information...